Colt Air Force Premium Grade 3341-NM Paired with M1 Garand Springfield Armory Air Force Premium Grade 3127763

*PLEASE READ ALL DETAILS IN THIS AREA. **

 **CMP 1911 Paperwork will be emailed the Monday morning after the Auction closes.

**YOU WILL NOT USE THE FIRST EMAIL YOU GET AFTER THE AUCTION CLOSES. YOU WILL GET A SECOND EMAIL FROM  khayden@thecmp.org . 

**You may only bid on ONE 1911 at a time!

**If you have already obtained a 1911 in 2024, you are NOT eligble to bid on this item. 

**If you bid and win this 1911 pistol but fail or decline to complete the purchase of the 1911 pistol then you are NO LONGER ALLOWED to bid on any more CMP 1911 Auctions! 

All Auction Pistols EXCEPT those in sealed package have been inspected and test fired but all pistols are as received. Please remember that these have been issued and used during their service life. They will have service wear and marks.  

Pistol should be inspected by gunsmith prior to firing. 

Colt Air Force Premium Grade AUCTION GRADE

Serial Number 3341-NM

Highlights:

1911A1

Slide: Colt

Frame: Colt

Barrel: Colt

The bore is Bright

Receiver Finish/Condition: Blued with very little wear

Markings & Other information: Colt AUCTION GRADE

Auction Grade Colt Air Force Premium Grade. All Metal parts in Good condition with a mix of Military finish. Pistol shows very little finish wear and hand stippling on Mainspring housing and Front strap. Right Receiver has the Serial Number.

Springfield Armory AIR FORCE PREMIUM GRADE

Serial Number 3127763

Highlights:

Muzzle: 0+

Throat: 1

Barrel: SA 1-63, Drawing # 7791035, 7.62mm, Stamped NM & AFPG

The bore of this rifle is Bright

Receiver: D28291 34/ B31B

Op-Rod: 6535382 SA

Bolt: D28287-12SA/ S-B10♢

Trigger Housing: D28290-14-SA

Hammer: C46008-7SA, contact points polished, hooks modified

Markings & Other information: Air Force Premium Grade in 7.62mm

The rifle is in overall Very Good condition. The Receiver has been polished at the op rod contact points, under the windage knob, and has a hole drilled to accept the spring and ball bearing for the ½ windage knob. The bolt has been polished on top and bottom w/ “7.62mm” etched on top. The rear sight has a NM hooded aperture and modified windage knob. The windage knob working w/ the ball bearing and spring in the receiver and the hood of the aperture give the rifle ½ MOA adjustments. The barrel is a SA 1-63 7.62mm NM. The bore is bright and has Very Good T/M readings. The belly of the barrel has been polished. NM and AFPG can be found stamped between the front and rear rings of the gas cylinder. The gas cylinder has had the rear ring inner diameter opened, the rear face cut back, and the rear shelf tapered to prevent contact w/ the front hand guard. The front sight has a reduced blade w/ NM 062 stamped on the right side. The trigger and hammer have been modified to improve the trigger pull. The front and rear hammer hooks have been cut, as well as the disconnector being cut at an angle and polished. The stock has no outside stamping, but has been bedded to the action and trigger group. The last 4 of the SN can be found stamped on the left side of the op rod channel behind the front ferrule. The front ferrule has been epoxied and screwed to the front of the stock. The front hand guard has been epoxied and screwed to the lower band.

Sold as is

All photos can be viewed here.